Panasonic DMC-G6KK User Manual
Page 342
342
Others
•
Upload may not complete when it is disconnected while transmitting the image.
•
It may take some time after uploading the image to be reflected in the web service depending
on the status of the server.
> Wait for a while and try again.
•
You can check the transmission status on the web service link settings by logging into “LUMIX
CLUB”.
•
The images in the web service cannot be saved (downloaded) to this unit. Do not delete the
uploaded images, and make a backup of them.
•
The images uploaded to the web service cannot be displayed or deleted by this unit.
> Perform the task using a smartphone/tablet or a PC.
•
The settings stored in the camera may be deleted depending on the type of repair.
> Always make a copy of important settings.
•
Is the size of the image too large?
> Divide the motion picture using [Video Divide]
> Reduce the image size at [Size].
•
Capacity or number of images in the web service is full.
> Login to “LUMIX CLUB”, and check the status of the destination on the web service link
settings.
> Execute the [Reset Wi-Fi Settings] in the [Setup] menu.
> However, all the information you have set on the [Wi-Fi Setup] menu, which includes the
“LUMIX CLUB” login settings, will be reset. (excluding [LUMIX CLUB])
•
Is the size of the image too large?
> Transmit after dividing the motion picture with [Video Divide]
.
> Reduce the image size at [Size]
, and then send.
> Image cannot be transmitted when the battery indicator is flashing red.
The image that was supposed to have uploaded to the web service is not there.
I would like to return the image in the web service to the camera.
I cannot display or delete the images uploaded to the web service by this unit.
Your “LUMIX CLUB” login ID and password were deleted after sending the
camera in to be repaired.
There is an image that could not be transmitted.
I have forgotten the password for the Wi-Fi.
Transmission of the image fails midway.
DMC-G6PDF-VQT4Z78_eng.book 342 ページ ２０１３年４月２５日 木曜日 午前１０時５分