ARCHOS TV+ - Manual (Page 5)

MANUAL V1.0 TV+ STARTING UP > P. 5
On the back of the device:
3. Reset button : ONLY use this button if you need to restart the Installation Wizard.
When you press this button, the ARCHOS will restart and a message will pop up
to confirm the relaunch of the wizard. If you do not respond within 10 seconds,
the wizard will be automatically relaunched. See: The Installation Wizard .
ATTENTION: if you use the reset button and relaunch the wizard, no
data will be erased but your TV connection settings will be lost, and you
will have to set them up again through the wizard.
4. SPDIF Out*:
to connect to an amplifier that has an SPDIF audio input (such as
a ‘home cinema’).
5. Audio/Video inputs and outputs : to connect to the Audio and Video con-
nectors of your TV (and tuner), using the supplied cables. Audio/Video inputs
and outputs available: RGB**, Component (YPbPr)*, Composite Video**, S-
Video***, Stereo Analog Audio.
Check the manual of your TV (and tuner) to see what types of connectors your
device has.
6. Ethernet connector*:
you can plug an Ethernet cable to connect to the
Internet and to your local network.
7. DC in : to connect the included power adapter.
In the event that your ARCHOS freezes or does not respond anymore,
disconnect the power adapter, wait for 15 seconds and reconnect it.
When the red LED indicator stops blinking, press the Power button on
the supplied remote control to turn on your device.
8. HDMI Out*:
to connect to a television that has an HDMI input (such as an ‘HD
Ready’ TV).
* requires optional cable(s)
** US: requires optional cable(s)
*** Europe: requires optional cable(s)