ARCHOS TV+ - Manual (Page 51)

MANUAL V1.0 TV+ MAIN SETTINGS > P. 51
* Most networks support DHCP.
If the network needs to be config-
ured manually, use the left/right ar-
rows to select the “ Manual ” setting
on the “ Configuration ” parameter.
Other parameters will appear: the
required information can be ob-
tained from the person who man-
ages the network.
•
•
When you have finished entering all the information, select the “ Connect ” button,
and your ARCHOS will connect to this network, provided the signal is strong enough.
Protected Networks (WEP, WPA or WPA2 KEY)
Protected networks require an en-
cryption key to connect.
The type of key (WEP, WPA or
WPA2) will be detected automati-
cally by your device.
The rest of the required information
can be obtained from the person
who manages the network.
•
•
•
You will have to specify the following settings:
“Key length” (for WEP networks only)
the authentication key can be 10 characters long (64bit) or 26 characters long (128bit).
“Key format” (for WEP networks only)
in some cases you may need to change the key format in order to enter a pass-
phrase/password. See the documentation that came with your WiFi router or modem.
“Key” (WEP or WPA)
press OK, enter the encryption key using the remote control’s keyboard and press
OK again to validate.
“Authentication” (for WEP networks only)
the network’s authentication method can be based on an “ Open System (de-
fault) ” or a “ Shared Key ”.
-
-
-
-