ADIC 4000 User Manual
Page 21
Description
2-7
Table 2-4
Front Panel Indicators and Controls
2-line by 20-character
LCD Display
Displays drive status, error messages, POST results
Beeper
Sounds whenever it is OK to operate the cartridge insert/
release handle. The green Operate Handle LED should be
ON
whenever the Beeper sounds.
Write Protected
(orange)
ON
= Tape write-protected.
OFF
= Tape write enabled.
Tape in Use
(yellow)
Blinking
= Tape moving.
ON
= Tape loaded; ready for use.
Use Cleaning Tape
(yellow)
ON
= Drive head needs cleaning, or the tape is bad.
OFF
= cleaning complete, or cleaning unnecessary.
Operate Handle
(green)
ON
= OK to operate the cartridge insert/release handle.
OFF
= Do not operate the cartridge insert/release handle.
Density Select 2.6
(yellow)
ON
= Tape is recorded in 2.6 GB format.
Blinking
= Tape is recorded in another density.
Density Select 6.0
(yellow)
ON
= Tape is recorded in 6.0 GB format.
Blinking
= Tape is recorded in another density.
Density Select 10.0
(yellow)
ON
= Tape is recorded in 10.0 GB format.
Blinking
= Tape is recorded in another density.
Density Select 20.0
(yellow) [4000DLT
only]
ON
= Tape is recorded in 20.0 GB format.
Blinking
= Tape is recorded in another density.
Density Select 70.0
(yellow) [7000DLT
only]
ON
= Tape is recorded in 70.0 GB format.
Blinking
= Tape is recorded in another density
Compress
(yellow)
ON
= Compression mode enabled.
OFF
= Compression mode disabled.
Density Override
(yellow)
ON
= Density selected from front panel.
OFF
(default) = Density selected from host.
Blinking
= In density selection mode.
Unload Button
Pressing this button initiates a manual unload of the tape.
This may take from 10 seconds to 4 minutes depending on
tape position.
Cartridge Insert/
Release Handle
Lift this handle (only when the Operate Handle LED is ON,
and after the momentary beep sounds) to load or eject a
cartridge from the drive. The handle lifts to the open
position and lowers to the closed position.