Antunes, AJ VCT-1000 - Manual (Page 12)

VERTICAL CONTACT TOASTER
12 P/N 1010807 Rev. E 06/06
MAINTENANCE (continued)
Replacing Optional Belt Wraps and
Measuring the Conveyor Belt Chains and
Optional Roller Tensioners (Every 3 - 6
months)
REPLACING BELT WRAPS
NOTE: Depending on toaster usage and how well
they are cleaned daily, the Belt Wraps should
last between 3 - 6 months. Additional Belt Wraps
may be purchased from your Authorized Service
Agency.
1. Turn unit off, unplug the power cord, and allow
the unit to cool before proceeding.
2. Remove the Bun Feeder and Heat Shield and set
the Bun Thickness Compression Knobs to 6 & 6.
3. Open both Conveyor Covers and pull the Belt
Wrap Pin out of the “zipper” (Figure 8).
4. Remove and discard the old Belt Wrap(s).
5. Clean both Conveyor Belt Chains just as you
would clean the Belt Wraps during daily cleaning
(Figure 8).
6. Install the new Belt Wrap(s) around the Conveyor
Belt Chains inside the yellow rods with the “zip-
per” flap exposed and hanging down (Figures 9 &
10).
CA UT ION
INCORRECT CORRECT
Figure 9. Installing Belt Wrap
Figure 10. Aligning Belt Teeth
Belt Wrap
Pin
Belt Rotation
Upper Support Rod
Lower
Support Rod
CAUTION
Position the Belt Wrap UNDER the upper and lower
yellow support rods or damage to the unit may occur.
CAUTION
Align the ends of the Belt Wrap properly (Figure 13)
or the Belt Wrap may be damaged.
Figure 8. Removing Optional Belt Wrap
Interlock
Switch
Conveyor
Cover Assy.
Belt Wrap
Pin
Replacing the Release Sheet (Every 4 - 6
weeks)
NOTE: Depending on toaster usage and on how
well it is cleaned daily, the Release Sheet should
last between 45 - 60 days.
1. Remove and discard the Release Sheet.
2. Lay a new Release Sheet on a clean, dry surface
and fold it in half lengthwise and gently crease it
at the fold using only your fingers.
3. Install the Release Sheet just as you would after
daily cleaning (see diagram below).
Fold over so
ends meet. Press Lightly with fin-
ger to form crease.
7. Close the Conveyor Cover(s), set the Bun
Thickness Compression Knobs back to their nor-
mal settings and reinstall the Heat Shield and Bun
Feeder.
Conveyor Belt
Chains