Antunes, AJ VCT-1000 - Manual (Page 8)

VERTICAL CONTACT TOASTER
8 P/N 1010807 Rev. E 06/06
INSTALLATION (continued)
Installing the Optional Belt Wraps and
Roller Tensioners
NOTE: Beltwraps and Roller Tensioners are
REQUIRED on models with manufacturing number
9210716 and 9210722.
INSTALLING BELT WRAPS
NOTE: Depending on toaster usage and how well
they are cleaned daily, the Belt Wraps should
last between 3 - 6 months. Additional Belt Wraps
may be purchased from your Authorized Service
Agency.
1. Ensure that the Rocker Switch (power On/Off) is
set to OFF, the power cord is unplugged, and the
unit is cool before proceeding.
2. Remove the Bun Feeder and Heat Shield and set
the Bun Thickness Compression Knobs to 6 and
6 (Figure 7).
3. Open both Conveyor Covers and install the Belt
Wraps around the Conveyor Belt Chains inside
the yellow rods with the “zipper” flap exposed and
hanging down (Figures 3 & 4).
4. Close the Conveyor Cover(s), set the
Compression Control Knobs back to their normal
settings and reinstall the Heat Shield and Bun
Feeder.
INSTALLING OPTIONAL ROLLER TENSIONERS
1. Install the Tensioner Assembly and reassemble
the unit (Figure 5).
2. Make sure the spacers are placed inside the
Tensioner arm. The spacers are smaller than the
holes to allow the Tensioner to pivot freely.
CA UT ION
INCORRECT CORRECT
Figure 3. Installing Optional Belt Wraps
Figure 4. Aligning Belt Teeth
Belt Wrap
Pin
Belt Rotation
Upper Yellow Support Rod
Lower Yellow
Support Rod
CAUTION
Position the Belt Wrap UNDER the upper and lower
yellow support rods or damage to the unit may occur.
CAUTION
Align the ends of the Belt Wrap properly (Figure 13)
or the Belt Wrap may be damaged.
Acorn Nuts
Tensioner
Assy.
Teflon
Tape
Spacers
Weld
Screws
Figure 5 Installing Optional Roller Tensioner
Assembly