Antunes, AJ VCT-1000 - Manual (Page 7)

7 P/N 1010807 Rev. E 06/06
VERTICAL CONTACT TOASTER
Figure 2. Installing Bun Chute
Bun Chute
Yellow
Support
Rod
Hook Bun Chute over rear
bottom conveyor cover
yellow support rod
Figure 1. Toaster and Accessories
Heat
Shield
Heat
Shield
Conveyor
Cover Assy.
(rear)
Yellow Support
Rod (front)
Conveyor
Cover Assy.
(rear)
Bun Feeder.
Conveyor
Cover Assy.
(front)
Unpacking
1. Remove unit and all packing materials from ship-
ping carton.
2. Open the large box. It should contain:
• Bun Feeder (Figure 1).
• Bun Chute (Figure 2)
• 2 Release Sheets (Figure 1).
• Authorized Service Agency Directory
• Owner’s Manual
3. Remove all packing materials and protective cov-
erings from the unit and parts.
NOTE: If any parts are missing or damaged, con-
tact Antunes Technical Service IMMEDIATELY at
1-877-392-7854.
Assembling the Unit
NOTE: The factory has pre-installed a Release
Sheet over the Platen (Figure 1). Verify that it is
properly in place before proceeding.
1. Install the Bun Feeder (Figure 1) and Bun Chute
(Figure 2).
IMPORTANT: Make sure Heat Shield Assembly
is properly seated and engages the Conveyor
Interlock Safety Switch (see Figure 1). The con-
veyors will not rotate unless the Heat Shield is in
place and correctly engages the Conveyor Interlock
Safety Switch.
NOTE: Check the Release Sheet to make sure it
is not caught in the conveyor. Additional Release
Sheets can be obtained through your authorized
service agency under part no. 7000249 (3 pack) or
7000250 (10 pack).
INSTALLATION
Release
Sheet
Yellow
Support Rod
(rear)
Bun
Feeder
Conveyor
Cover Assy.
(rear)
Shown without option-
al Roller Tensioners
and Belt Wraps.
Shown without optional
Roller Tensioners and
Belt Wraps.
CAUTION
Failure to use Release Sheets may result in damage
to the unit and loss of warranty coverage.
Rear
Conveyor
Belt Chain
Front Conveyor
Belt Chain
Platen
Conveyor
Interlock Switch