Antunes, AJ VCT-1000 - Manual (Page 14)

VERTICAL CONTACT TOASTER
14 P/N 1010807 Rev. E 06/06
MAINTENANCE (continued)
Replacing the Optional Roller Tensioners
1. Remove the acorn nuts and old roller Tensioner
Assembly (Figure 12).
2. Replace Tensioner Assembly, and reassemble.
3. Make sure the spacers are placed inside the
Tensioner arm. The spacers are smaller than the
holes to allow the Tensioner to pivot freely.
Weld
Screws
Acorn Nuts
Spacers
Tensioner
Assy.
Teflon Tape
Figure 12. Replacing Roller Tensioner Assy.
Measuring the Optional Roller Tensioners
1. Measure the Roller Tensioner on both inner
Conveyor Covers (Figure 14)). Adjust or replace
any damaged ones as recommended. The space
between the inner Conveyor Cover and bottom of
the Tensioner wheel should be 13/16” (2.1 cm) or
the height of a U.S. Nickel.
Figure 14. Measuring Roller Tensioner
Figure 13. Replacing Spring Tensioner Assy.
Weld
Screws
Acorn Nuts
Spring
Tensioner
Assy.
Replacing the Spring Tensioners
1. Remove the acorn nuts (Figure 13).
2. Remove old Spring Tensioner Assembly.
3. Replace Tensioner Assembly and reassemble
unit.
Teflon Tape