Arkon Channelmag User Manual
Page 13
Advertising
13
ChannelMag
Section 2 Installation
2.4.2 Installation of 2 x CM2
ChannelMag Sensors
Adjust width before installation into channel 2.00” 50m
Lifting brackets. Do not lift by the Actual CM2 Width enhancement plates.
For CM2 sensors installed in a recess in the bed of the channel, the installation configuration remains the same. 1/4” (6.3mm) thick base
plates with the recess must extend over the full channel width, countersunk 1/4” screws from the bottom
Advised Width of Channel
The height E of the magnetic enhancement plates is custom made and normally extends to 4”
(100mm) nominally above the maximum level. The width W is adjustable to fi t the channel
width. W includes the mounting brackets.
Note
Advertising