Wearing the heart rate sensor, Backlight alarm – CatEye MSC-HR10/MSC-HR20 User Manual
Page 8
15
14
4.0
3.5
3.6
Electrode pad
Back side
WEARING THE HEART RATE SENSOR
The Heart Rate Sensor is used to count your heartbeat and transmit the data to the MSC-HR10/20.
To wear the Heart Rate Sensor:
1. Wet the conductive pads on the underside of the Heart Rate Sensor with a few drops of water or a
conductive gel to ensure solid contact.
2. Strap the Heart Rate Sensor across your chest. To ensure an accurate heart rate signal, adjust the
strap until the belt sits snugly below your pectoral muscles.
NOTE:
•
The position of the Heart Rate Sensor affects its performance. Move the Heart Rate Sensor along the strap so that it falls
above your heart.
•
Avoid areas with dense chest hair.
•
In dry, cold climates, it may take several minutes for the Heart Rate Sensor to function steadily. This is normal and should
improve with several minutes of exercise, or by wetting the sensor contacts.
•
If the watch is kept idle without receiving a heart rate signal for 5 minutes, the Heart Rate receiving function turns OFF and
return to the Clock mode.
BACKLIGHT
ALARM
The MSC-HR10/20 also has an alarm. Follow the steps below to set it.
•
From the Clock mode press the SET button.
•
The current Alarm time appears. Press the ST/SP/+ or the MEM/- button to turn on or off the alarm.
•
Press the SET button for two seconds to change the hour and minutes.
•
The hours are flashing. Adjust and press the SET button.
•
The minutes are now flashing. Adjust and press the SET button.
•
Press the MODE button to exit the setup.
When the Auto-light is set to OFF:
•
Press LIGHT button to turn on the backlight for 3 seconds. Press any other key whilst the light is on
and it will extend the light time by another 3 seconds.
When the Auto-light is set to ON:
•
Press any key to turn ON or extend the backlight for 3 seconds.
To help conserve power, the Auto-light setting will automatically switch to OFF after 2 hours.
NOTE:
The backlight does not work when the low battery icon is shown and will return to normal once the batteries are replaced.