HOUNO CV ovens - Manual (Page 5)

5
Setting of time, temperature in oven chamber and core temperature
Press the key of the desired function (12 – 17).
Press the key of time (2), of oven temperature (6) or of core temperature (9).
The figure flashes.
Set the values with the arrow keys (4) (11).
One push on the key = one unit
Continuous pushing = quick setting
When the value has been set, the time, for instance, flashes for a few seconds, after which the
setting is automatically ‘locked’.
BUT: By pressing time again, the setting is locked at once.
For simultaneous setting of temperature (6), press the symbol while the time is flashing. The
time is ‘locked’ and the temperature flashes. Use the arrow keys and repeat the procedure.
The same applies to the setting of core temperature (9); however, this function should first be
activated with the ON/OFF key.
(1) Time display
The time remaining is displayed, while the program is running.
If any operational defects occur, an error code appears in the time display (see “Error Codes”).
(2) Time
The time can be set from 1 min. to 23 hours and 59 min.
When the time has run out, the steamer automatically stops and an alarm sounds.
The pre-set time can also be changed while the program is running.
(3) Continuous operation
Set the steamer at continuous operation by pressing
If the core temperature is on at the same time, the steamer stops when the core temperature is
reached.
(5) Display for oven chamber temperature
This display shows the pre-set temperature.
The control lamp in the left-hand corner lights while the heating elements are active. See (7) for
checking of temperature in oven chamber.