Power Soak 35351 Skewer Soak INstallation Manual - Manual (Page 15)

11
Using two nuts, attach the drain handle bracket to the studs on the bottom
of the tank. Insert the drain valve handle through the bracket and into the
drain body. It may be necessary to rotate the handle a partial turn to align
the flats on the end of the handle shaft with the flats on the valve so that
the handle will fully insert into the valve. Secure the handle to the valve
body by screwing the handle nut onto the valve body connection.
While holding the drain body to prevent it from rotating, tighten the flange
nut with a wrench to firmly seat the nut against the rubber vibration ring
and the vibration ring against the surface of the sink (approximately ¼ turn
past “hand tight”). Wipe or trim the excess sealant from around the drain
flange inside the sink. If silicone is used, allow the sealant to dry before
filling the sink with water (see instructions on the side of the sealant
container for drying time). After the sealant has dried, fill the sink with
water and check for leaks around the drain. Plumber’s Putty does not
require a drying time and may be leak tested right away.
HANDLE
BRACKET
HANDLE
HANDLE NUT
VALVE BODY
CONNECTION
FOR HANDLE
DRAIN
BODY
NUTS