Power Soak 35351 Skewer Soak INstallation Manual - Manual (Page 8)

4
Removal of Existing Unit
If the new Skewer Soak is not replacing an existing sink, skip this section.
If the removal of an existing sink is necessary, continue with this section.
Existing Supply Lines
The water and electrical source must be shut off before disconnecting or
cutting the water or electric lines.
Disconnect any electrical cord that is connected to the existing sink. Cut
the cold and hot water lines as closely as possible to the fittings on the
existing sink. IMPORTANT: Be sure to leave enough of the existing
piping for the installation of new shutoff valves. See “Pre-Plumbing”
section for reference.
Existing Sink Removal
Detach any fasteners holding the existing sink in place and remove the
existing sink along with any shelves that may interfere with the installation
of the Skewer Soak. Discard all unwanted materials in an appropriate
container or disposal area.
Wall Preparation
Clean the wall(s) where the new Skewer Soak will be installed. Fill all
existing holes with an appropriate filler material (caulk, silicone, hole plug,
etc…). Be sure that any outlet that will be covered by the sink has been
disconnected and a water tight cover has been installed over the opening.
Failure to shut off the electrical and water supply will result in personal injury,
including serious injury or death, and extensive equipment damage.
WARNING