Power Soak 34201 PRODUCE SOAK OWNER'S MANUAL - Manual (Page 38)

36
The installation and initial operational check of your
new system must be performed only by licensed and
certified plumbers and electricians.
Be sure to follow all applicable national and local
electrical codes when installing the electrical supply
and/or a new circuit breaker. DO NOT connect the
system using a power cord and plug or an extension
cord of any kind.
Please refer to the detailed installation instructions that were sent with your
Produce Soak system.
Electrical Requirements
The electrical requirements of your new system are on the serial number
plate located on the end of the wash sink near the front, adjacent to the
control panel enclosure. They are also shown inside the control panel
enclosure itself.
All Produce Soak systems have a single point electrical connection, and a
dedicated circuit is required.
The system is completely pre-wired and tested at the factory, and a hard-
wired connection from an appropriate power source is all that is required.
The installer is to provide a NEMA 3X disconnect that should be
incorporated in the fixed wiring.
Properly sized watertight conduit, fittings and parts are required, as well as
the appropriate gauge wire.