Power Soak 34201 PRODUCE SOAK OWNER'S MANUAL - Manual (Page 39)

37
If your system is a “left-to-right” unit, you should locate the disconnect at
the left end of the system.
(The opposite would be true for a “right-to-left”
system.)
Ideally, the disconnect should be located on the wall directly behind the
pump motor and control panel provided this location is easily accessible by
the operator and does not interfere with the faucet.
A wiring diagram is located in the system’s control panel enclosure.
Specific part numbers and parts information can be obtained from the
factory by calling 800-444-9624.
Plumbing Requirements
Your unit requires the following plumbing connections:
 3/4” (19mm) or 1/2” (12 mm) hot and cold water supply lines.

One waste w
ater connection (minimum 1 1/2” / 38mm).