American Electric Lighting AVL, ASA, VMR, VLR, PES & PEM User Manual
Warning, S3, s7, p3 p7 options)
Installation:
Attach tenon slipfitter to luminaire by guiding it over the fitter base, being careful to align it with the roll pins on the bottom of the fitter base
Thread the center bolt into the slipfitter and tighten from topside of splice compartment. Feed supply wires from the pole through tenon
slipfitter into splice compartment. Slide fixture with slipfitter attached onto the pole tenon. Orient the fixture for appropriate light throw
(if required). Alternately tighten 3/8” set bolts until fixture is in desired position and all set bolts are securely tightened. Make wire con-
nections in splice compartment being sure to observe proper polarity. Tuck wires neatly into splice compartment. Place splice compart-
ment cover onto unit and secure with screw provided. Recheck all bolts and hardware to ensure it is properly secured.
Wires should not be energized during installation and maintenance. Options are to be installed in the field. DO NOT alter fittings when
mounting the fixtures. Recheck all connections and bolts to insure they will not loosen due to vibration.
Square Pole Fitter:
S3
For 2-3/8” O.D. Tenon
S7
For 2-7/8” O.D. Tenon
Round Pole Fitter:
P3
For 2-3/8” O.D. Tenon
P7
For 2-7/8” O.D. Tenon
Dimensions and specifications on this page are
based on the most current available data and are
subject to change without notice.
INSTALLATION INSTRUCTIONS
PES/PEM, VLR/VMR, ASA, AVL
SERIES MOUNTING OPTIONS
(S3, S7, P3 P7 OPTIONS)
American Electric Lighting, a division of Acuity Brands Lighting, Granville, OH
DRAWING NO. A72261 REV B
(FRONT)
©2009 ACUITY BRANDS LIGHTING, INC. ALL RIGHTS RESERVED
PART NUMBER 057-71-72261
WARNING
!