American Electric Lighting AVL, ASA, VMR, VLR, PES & PEM - Manual (Page 2)

Installation:
Reference the mounting plate detail below, secure mounting plate to the wall or wood pole with two (2) 5/8” fasteners (supplied by others).
Start to thread the rods into the matching holes in the mounting plate. Three to four full turns is needed. Place one of the enclosed gaskets
over threaded rods and against bracket.
On the top of the arm is a label which reads “TOP . . .this end towards fixture.” To mount arm, slide arm over threaded rod using the bolt-
guides inside arm. Again check to see “TOP” label is on top of arm and towards fixture end of the arm. Place remaining gasket over
threaded rods and against mounting arm.
To mount fixture, align the mounting holes (inside of fixture) with the threaded rods protruding through the end of the arm. Insert threaded
rods into fixture, being careful to align gasketing between fixture housing and mounting arm. Install split lockwashers and cap nuts
(furnished) on threaded rods and tighten securely. During this process, be sure the fixture is mounted straight on wood pole or wall.
Make wiring connections. Because wiring connections are made in the mounting arm, 60°C wire is allowed for supply leads. Apply
continuous bead of WEATHER-PROOF CAULKING BETWEEN MOUNTING PLATE AND WALL TO ENSURE WEATHERTIGHT
INTEGRITY.
Options are to be installed in the field. DO NOT alter fittings when mounting the fixtures. Recheck all connections and bolts to insure
they will not loosen due to vibration.
WP Assembly Mounting Plate Detail
Dimensions and specifications on this page are
based on the most current available data and are
subject to change without notice.
Note: This drawing is not to scale and should be used for dimensional purposes only.
Wood Pole / Wall Mounting:
WP 12” Arm (12”L, 5”W, 2”D)
INSTALLATION INSTRUCTIONS
PES/PEM, VLR/VMR, ASA, AVL SERIES MOUNTING OPTIONS
(WP OPTION)
DRAWING NO. A72261 REV B (BACK) PART NUMBER 057-71-72261
WARNING
!
MOUNTING
LABEL
GASKET
POLE OR WALL MOUNTING PLATE
CAP NUT
2 REQUIRED
SPLIT LOCKWASHER
2 REQUIRED
LOCKWASHER
2 REQUIRED
POLE MOUNTING ARM
THREADED ROD
2 REQUIRED
7/8” CONDUIT
ENTRY HOLE
5.13 5.13
1.25 1.25
.63 .63
.44 .44
2.56 2.56
4.69 4.69
MOUNTING HOLES (2)
7/8” CONDUIT
ENTRY HOLE
American Electric Lighting, a division of Acuity Brands Lighting, Granville, OH
©2009 ACUITY BRANDS LIGHTING, INC. ALL RIGHTS RESERVED