American Electric Lighting AVL, ASA, VMR, VLR, PES & PEM - Manual (Page 6)

Installation:
(1) Remove optical assembly and set aside. 2) Pull input wires into housing. 3) Place fitter (3” wide x 5 ¼” tall x 5.3” deep) A and gasket
B against housing. Install 2-1/2” x 13” x 1” D bolts with lock washers C from the inside of the housing and tighten B
properly. 4) Feed wires from electrical components (input wires) through housing into fitter. 5) Reverse step #2. 6) Reverse step #1. 7)
Use thru-bolt hole provided E (center of hole “E” to end of fitter=2”) as pilot and drill 9/16” hole through mast arm G if needed.
Mast arm may already be pre-drilled. 8) Install mast arm G (not included) 2-3/8” max. Insert bolt H through fitter A and
mast arm G for additional lock down. 9) Tighten all three set screws F equally.
INSTALLATION INSTRUCTIONS
PES/PEM, VLR/VMR, ASA, AVL SERIES MOUNTING OPTIONS
( EF OPTION)
DRAWING NO. A72261 REV B (BACK SHEET3) PART NUMBER 057-71-72261
Options are to be installed in the field. DO NOT alter fittings when mounting the fixtures. Recheck all connections and bolts to insure
they will not loosen due to vibration.
WARNING
!
EXTERNAL MAST ARM FITTER:
EF For 2 3/8’ O.D. MAST ARM
Dimensions and specifications on this page are based on the most
current available data and are subject to change without notice.
American Electric Lighting, a division of Acuity Brands Lighting, Granville, OH
©2009 ACUITY BRANDS LIGHTING, INC. ALL RIGHTS RESERVED