Beijer Electronics EPC C2D Box Nautic EN - Manual (Page 18)

Description of Parts
18 Beijer Electronics, MAEN979B
5.9 ATX Remote Connector
The ATX remote terminal is a double-pole connector close to the red ATX pow-
er switch button. It is parallel connected to the button. An external push-button
switch or a relay contact can be connected to the ATX remote connector.
5.10 Compact Flash Memory Card
An external Compact Flash memory card can be used for data storage. Some
EPC models also allow mounting an internal Compact Flash memory card as a
boot-up device, or for data storage.
If a Compact Flash memory card is mounted in/removed from a running EPC,
the EPC must be restarted in order to detect the system change.
Booting from a Compact Flash Card
Follow the instructions below, in order to boot the EPC from an internal Com-
pact Flash card:
– Make sure that the Compact Flash card is used as local drive. Standard Com-
pact Flash cards are available only as removeable drives for data storage.
– Confirm that the Compact Flash card is set as first boot device in the BIOS
in order to boot the operation system from it.
– Removing the Compact Flash card while the EPC is running may damage the
operating system.
Note:
Only Compact Flash cards distributed by Beijer Electronics may be used. Third par-
ty products may cause system malfunction or performance loss.