Beijer Electronics iX Panel K70 EN - Manual (Page 23)

Hardware Replacement
8.3 Replacing the Rear Cover
The following is needed:
• A new rear cover, see Available Spare Parts for iX Panel K70
• A torx T10 screwdriver
Note:
Make sure to use adequate ESD protection.
Follow the steps below to replace the rear cover:
1. Power off the operator panel.
2. Remove the rear cover of the operator panel by loosening the 4 torx screws.
4 x torx screws
3. Re-assemble with the new rear cover in reverse order.
Beijer Electronics, MAEN002 23