Beijer Electronics iX Panel K70 EN - Manual (Page 24)

Hardware Replacement
8.4 Replacing the Display/Display
Cable
The following is needed:
• A new display including plastic frame and display cable, see
Available Spare Parts for iX Panel K70
• A torx T10 screwdriver
Note:
Make sure to use adequate ESD protection.
Follow the steps below to replace the display/display cable:
1. Power off the operator panel.
2. Follow the instructions under
Replacing the Rear Cover to remove the rear
cover.
3. Disconnect the three flex cables from the power card, according to the
illustration below, and remove the two plastic nuts that hold the power card
in place.
plastic nut
plastic nut
flex cables
4. Lift the power card and gently remove the backlight cable from the rear side.
backlight cable
snap-in closure for plastic frame
guide pins
guide pins
5. Gently loosen the complete plastic frame and display from the front plate.
Scrap the display and frame.
6. Mount the new display/display cable and frame and re-assemble the complete
operator panel. Make sure the guide pins on the frame are properly fastened in
the holes in the front plate.
Beijer Electronics, MAEN002 24