Beijer Electronics iX Panel K70 EN - Manual (Page 29)

Service Menu
9 Service Menu
The service menu for the operator panel can be accessed before a project is
downloaded, or by setting the mode switches in mode 1000. The location of the
mode switches is described in the
Mode Switches section.
9.1 Service Menu in an Empty Panel
When no project is loaded in the panel memory, the panel will boot, displaying the
Welcome screen. Press anywhere on the panel display to enter the service menu.
9.2 Service Menu in a Panel with
Project
When a project is loaded in the panel memory, the panel will automatically start to
execute the project. To display the service menu at boot-up:
1. Disconnect the power supply from the panel.
2. Set the mode switches in mode 1000 (Service Menu mode).
3. Connect the power supply.
4. Make desired settings in the service menu.
5. Disconnect the power supply from the panel.
6. Set the mode switches in mode 0000 (Run mode).
7. Reconnect the power supply.
9.3 Service Menu Options
The following options are available in the Service Menu:
9.3.1 IP Settings
Select to obtain an IP address automatically via DHCP, or specify an IP address.
The IP address can also be set during project transfer.
9.3.2 Date/Time
Use the Date/Time Settings dialog to set the time zone, date and time for the
panel.
9.3.3 Erase Project
The erase function will detect if the project is located in the panel memory or on a
memory card. Pressing Erase Project will completely remove the project and all its
components from the panel memory/the memory card.
Beijer Electronics, MAEN002 29