5 replacing the complete front – Beijer Electronics iX Panel K70 EN User Manual
Page 26
Advertising
Hardware Replacement
8.5 Replacing the Complete Front
The following is needed:
•
A new front, see
Available Spare Parts for iX Panel K70
•
A torx T10 screwdriver
Note:
Make sure to use adequate ESD protection.
Follow the steps below to replace the complete front of the iX Panel K70:
1. Power off the operator panel.
2. Follow the steps 1-3 and 5 in the
Replacing the Display/Display Cable
instruc-
tions, but in step 3, do not remove the display cable .
3. Attach the new front.
4. Re-assemble the unit.
Beijer Electronics, MAEN002
26
Advertising