Hawk Industries Spinner Manual 550 HYDRAULIC Serial Numbers 1 to 205 - Manual (Page 32)

32 Maintenance & Repair
Air Power Pack Maintenance
MS SD
SIGHT DOME GASKET
OUTER SIGHT DOME
BODY
INLET SEAL
PICKUP TUBE
SEAL
FILL CAP
INJECTOR INLET
INJECTOR CONE
RESTRICTOR
BASE SEAL
WHISTLE
BASE
CHECK BALL
CHECK BALL SPRING
DRAIN INSERT
INSERT SEAL
MOUNTING NUT
DRAIN ASS'Y
METER BLOCK TOPSEAL
METER BLOCK
BOWL SEAL
CHECK BALL
CONNECTOR,
PICKUP TUBE
BOWL ASS'Y
SEAL, METER BLOCK
INNER SIGHT DOME
SEAL, METERING SCREW
1. The proper adjustment to the
air lubricator saves oil and
maximizes air motor perfor-
mance.
2. Using a small flat screw driver,
rotate the lubricator metering
screw (MS) counter-clockwise
to increase oil flow and clock-
wise to decrease oil flow.
3. The proper adjustment is one (1)
drop per minute to minute and
one half when Spinmaster's
main motor is idle, or two (2-3)
drops per connection when
Spinmaster main motor is in
use. To adjust the lubricator, the
power pack must be turned on.
4. Lubricator drops can be seen at
the lubricator sight dome (SD)
located on top of the lubricator as
shown.
Air Lubricator Adjustment
002-L17 Air Lubricator
Air Lubricator Maintenance
MANUAL DRAIN 002-L17-2
ITEM P/N