Rhin-O-Tuff HD4170 - Manual (Page 10)

9
Mounting the HD-4170 onto the HD-6500, HD-7000 or HD-7700;
See Illustration 5.0.
Your HD-4170 Coiler came in the stand-alone configuration. In order to attach
the HD-4170 Coiler you need to remove the feet. Inside the HD-4170 shipping
box is a knob kit with tools. Locate the small Allen wrench
and remove both
feet from each side of the HD-4170 Coiler. Do not remove the Interface Plate
that mounts directly to the HD-4170 Coiler bottom side. Store the feet, screws
and Allen wrench for future use. Locate the Interface Blocks, screws, Allen
wrenches, and 3-winged knobs
provided inside the shipping box. These will
be required in the next step.
HD-6500 and HD-7000 Instructions;
See Illustration 5.1 on next page.
Locate the two top-most and rear-most
screws on the side of your HD-
6500/7000. Inserting the short end of
the Allen wrench into the screw head,
remove the two screws.
HD-7700 Instructions;
See Illustration 5.2 on next page.
Locate the two top-most and forward-
most screws on the side of your HD-
7700. Inserting the short end of the
Allen wrench into the screw head,
remove the two screws.
Both HD-6500/7000 and HD-7700 Instructions cont...
Store the two screws removed from the punch. Locate one of the
Interface Blocks and orient it against the two now-available holes.
Orient the block so that the interface block oval hole
is forward
and the counter bores face out. To the right is an example of a
counter bore. Use the longer ¼”-20 socket head screws provided to secure the
block to the machine with the short end of the Allen wrench. Tighten the rear
screw first then the forward screw. Repeat this step on the other side of your
punch with the other block.