Muxlab VGA 4x1 Switcher - Manual (Page 12)

© MuxLab Inc. VGA 4x1 Switcher Installation Guide
Page 12
7. Connect a Cat 5e/6 (or better) UTP cable between
the VGA 4x1 Switcher and the Active VGA Balun II
Receiver.
8. The Active VGA Balun II features a gain
compensation rotary switch and a potentiometer for
equalization. For more information, please refer to
the Active VGA Balun II Installation Guide.
9. The factory default setting of the switcher upon
power-up is automatic port selection mode. To select
a port manually, press the push button until the
Select LED of the desired port is illuminated. To
switch back to automatic mode, hold the pushbutton
down for 3 seconds. The amber Auto LED will
again be ON.
10. Assemble the infrared remote control as shown in
Figure 3. To manually select the desired port with
the infrared remote control, press the numbered
buttons. To switch back to automatic mode, press the
Auto Mode button.
Figure 3: Infrared Remote Control Assembly