Muxlab VGA 4x1 Switcher - Manual (Page 20)

© MuxLab Inc. VGA 4x1 Switcher Installation Guide
Page 20
they are selected to be fed to the output port. The
Configure Device tab deals with naming a Switcher,
along with each of its input ports, as well as the COM
port on the PC to which the Switcher is connected.
Once all hardware has been connected, the user must
perform the following three steps:
1. Load a device
2. Configure a device
3. Choose a port selection method for a device
1. Loading a Device
Loading a device consists of detecting a Switcher (or
other software-controllable MuxLab product) connected
to the PC. Loading can be done either automatically or
manually. Once a device has been successfully loaded, it
will be displayed in the Devices tree.
To load devices automatically, select Devices>Load All
Connected Devices… (Figure 13).
Figure 13: Loading All Connected Devices