Muxlab VGA 4x1 Switcher - Manual (Page 19)

© MuxLab Inc. VGA 4x1 Switcher Installation Guide
Page 19
3.8. MuxLab Control Center Software
MuxLab provides the user with software for operating
the VGA 4x1 Switcher via a PC. Each Switcher has 4
input ports and 1 output port, and the MuxLab Control
Center software enables the user to select which input
port to feed to the output port.
To install the MuxLab Control Center software, insert
the USB flash drive into the PC, open the folder, and
double click the SC-000015 file.
When running the MuxLab Control Center software for
the first time, the main window will appear (Figure 12).
Figure 12: MuxLab Control Center Main Window
On the left is the Devices tree, and on the right are the
Port Selection and Configure Device tabs. A device
may be a Switcher (as in this case), or any other
software-controllable MuxLab product. Depending on
the type of device selected, the tabs on the right will
change. For a Switcher, the Port Selection tab deals
with the Switcher’s input ports, and the way in which