Muxlab VGA 4x1 Switcher - Manual (Page 13)

© MuxLab Inc. VGA 4x1 Switcher Installation Guide
Page 13
11. In order to control the Switcher via USB, connect
the USB cable between the Switcher and the PC.
Similarly, to control the Switcher via RS232,
connect an RS232 cable (not included) between the
Switcher and the PC. Refer to Section 3.6 for the
RS232 cable configuration. Note: Connect only a
USB cable or an RS232 cable (not both) between the
Switcher and the PC.
12. Figure 4 shows a typical configuration.
Figure 4: Typical Configuration