Muxlab VGA 4x1 Switcher - Manual (Page 9)

© MuxLab Inc. VGA 4x1 Switcher Installation Guide
Page 9
3.3. Pre-Installation Checklist
The VGA 4x1 Switcher works in conjunction with the
Active VGA Balun II Kit (500140), the Active VGA
Balun II Transmitter (500141), the Active VGA Balun II
Receiver (500142), and Balun Power Supply (500144).
1. Verify that you have all the components necessary to
install the complete system and determine the final
location for each piece of equipment.
2. One (1) Kit (500140) is needed to support the first
source. Each Kit includes one (1) Transmitter
(500141), one (1) Receiver (500142), and two (2)
Power Supplies (500144).
3. One (1) additional Transmitter (500141) is required
for each additional source.
4. Consult the Technical Specifications to determine
whether the Switcher and Active VGA Balun II
components are within MuxLab distance limitations
for Remote Power. If so, only the Switcher needs to
be powered.
5. If extended distance is required beyond the limits of
Remote Power, verify that each Active VGA Balun
II component is powered by its own power supply.
Additional 12VDC/0.5A Balun Power Supplies
(500144) may be ordered from your MuxLab
distributor.