Atari 040-0050-01 - Manual (Page 2)

Preface
GVR SX Conversion System Manual
Page 2 of 48
040-0050-01
Rev. A 10/29/2004
Table of Contents
Preface .......................................................3
Safety ...........................................................3
Warnings ...................................................3
Environmental Conditions ........................3
FCC Notices (United States).....................4
Section 1 – Game Description .....................5
Section 2 – Cabinet Conversion...................6
Upgrade Steps ..............................................6
Clean and Prepare the Cabinet.....................6
Remove old Tournament Header
and Card Reader.....................................7
Conversion Kit Contents and
Replacement Parts List ..........................8
Replace the Monitor (Optional) .................10
Remove the Old Monitor ........................10
Adapt the Cabinet for the Larger
Monitor ................................................10
Install the New Monitor ..........................12
Install the Cabinet Exhaust Fan .................13
Set Up the Hardware..................................15
Set Up AC Power Distribution................15
Remove the Game PCB and Install
New Hardware .....................................16
Connect the Jamma Conversion
Board and UVC....................................17
Install the Happ UGCI Board .................18
Set Up the Computer...............................19
Connect the Computer ............................20
Secure the Computer...............................21
Upgrade the Control Panel.........................22
Prepare the Control Panel .......................22
Apply Control Panel Graphics ................22
Install Buttons and Connect Wiring........23
Apply the Cabinet Graphics and
Marquee Artwork .................................24
Apply the Serial Number Sticker ............25
Section 3 – Power ON and Test the
Cabinet .....................................................26
Run the Joystick Calibration Utility ..........26
Adjust the Universal Video
Converter (UVC) .................................27
Section 4 – Using the Game Operator
Menu .....................................................28
Setting Game Options and Resets..............28
Machine Menu ...........................................29
Game Mode Menu .....................................30
Game Resets Menu ....................................31
Coin Audits ................................................32
Game Purchase Audit.................................32
Game Selection ..........................................33
Player Control Test.....................................33
Monitor Calibration Test............................34
Section 5 – Starting a Game.......................35
Playing a Beach Head Game......................36
USB Game Dongles...................................37
Section 6 – System Software CDs .............38
Operating System Restore CD ...................38
Game Software CDs ..................................38
Section 7 – Troubleshooting ......................39
Section 8 – Diagrams and Schematics .......43
Computer Rear Panel Diagram ..................45
Warranty Service........................................46
Warranty Information..............................46
Technical Support ......................................48
Table of Figures
Figure 1. Drilling Cabinet Air Holes.............13
Figure 2. Typical Jamma Conversion
Board and UVC Connections...............17
Figure 3. Happ UGCI Board
Connections..........................................18
Figure 4. Finished Control Panel...................22
Figure 5. Simplified Wiring Diagram ...........43
Figure 6. Detailed Wiring Diagram...............44
Figure 7. Computer Rear Panel
Diagram................................................45