ARRI 535B - Manual (Page 48)

48
SUB MENU
FORMAT 1
POSITION
EDGE 1
> WHITE
LEVEL 3
OUTSIDE FULL
EXIT
SUB MENU
FORMAT 1
POSITION
EDGE 1
WHITE
LEVEL 3
> OUTSIDE FULL
EXIT
6.3.3 White Level –
Setting the brightness
of the Format Markings
The brightness of the format markings can be set to black
(0), dark gray (1), light gray (2) or white (3).
• Move the cursor > with the keys ß and ü to the line
WHITE. Pressing the key ä will switch the settings
from 0 to 1 to 2 to 3 and back to 0, pressing the
key ö will switch the settings in the opposite direction.
6.3.4 Outside – Darkening the Area
outside the Format Markings
Note: This function is only available if one format
marking is activated. No darkening function is
available if there is no format marking or if two
format markings are switched on.
The brightness of the area outside of one format marking
can be reduced electronically to emphasize the important
image area. The setting FULL shows the outside area
with normal brightness, the setting DARK will reduce
the brightness of that area.
Inser
ter Facilities