Kramer Electronics VS-41HDCP - Manual (Page 11)

8 VS-41HDCP - Operating the VS-41HDCP
6 Operating the VS-41HDCP
This section describes how to:

Operate the PC and DVD modes (see Section Section
‎6.1
)

Acquire the EDID (see Section ‎6.2 )

Control the machine via the REMOTE terminal block connector (see
Section
‎6.3
)

Control the machine via the ETHERNET port (see Section
‎6.4
)

Control the machine via the Web pages (see Section ‎6.5 )
6.1 The PC and DVD Modes
The VS-41HDCP has two operation modes that are specific per input: the PC
mode (which is the factory default) and the DVD mode. The PC mode is used
when connecting a computer or several computers to one or more of the inputs.
The DVD mode is used when connecting a DVD or several DVDs to the inputs.
The PC mode and the DVD mode can be applied to a single input or to several
inputs. For example, if you want to connect a computer to INPUT 1, another
computer to INPUT 2, and DVD machines to INPUT 3 and INPUT 4, set INPUT 1
and INPUT 2 to the PC mode and INPUT 3 and INPUT 4 to the DVD mode.
To set the inputs to either the PC or DVD mode, do the following:
1. Turn off the POWER.
2. Press the PANEL LOCK button while turning the POWER on again.
3. Keep pressing and holding the PANEL LOCK button for a few seconds and
then release it.
The LOCK button blinks.
If an input button illuminates, this indicates that that input is set to the DVD
mode.
If an input button is not illuminated, this indicates that that input is set to the
PC mode.