Kramer Electronics VS-41HDCP - Manual (Page 12)

VS-41HDCP - Operating the VS-41HDCP 9
9
4. Toggle between the PC mode (input button not illuminated) and the DVD
mode (input button illuminated) by pressing that input.
5. Press the PANEL LOCK button to exit this mode.
The following table summarizes the differences between the PC mode and the
DVD mode:
PC Mode DVD Mode
The input is connected to a computer The input is connected to a multimedia
application, such as a DVD, a set top box and
so on
The EDID is available at all times (to
prevent computer reset) The EDID is available only when that input is
connected to an output
The input EDID source is the default EDID
or an acquired EDID (see
Section ‎6.1 )
The input EDID source is acquired directly from
the connected output
Note, that even if an input is set to the PC mode, you can connect a DVD player to
that input and vice versa, a PC can be connected to an input that was set to the
DVD mode.
6.2 Setting the EDID
You can acquire or change the EDID (see Section ‎6.2.1 ) or reset the machine to
the default EDID (see Section
‎6.2.2
).
If the connected output (for which EDID has already been acquired) is
disconnected, the EDID button blinks and then ceases blinking when reconnecting
the same output. When a new output is connected the EDID button blinks to
indicate that new EDID information must be acquired.