Kramer Electronics VS-41HDCP - Manual (Page 9)

6 VS-41HDCP - Connecting a VS-41HDCP 4x1 DVI Switcher
5 Connecting a VS-41HDCP 4x1 DVI Switcher
Always switch off the power to each device before connecting it to your
VS-41HDCP. After connecting your VS-41HDCP, connect its power
and then switch on the power to each device.
To connect the VS-41HDCP 4x1 DVI Switcher (as illustrated in Figure 3 ), do the
following:
1. Connect up to four computer graphics sources to the inputs (1 to 4).
You do not have to connect all the DVI sources.
2. Connect the OUTPUT DVI connector to a DVI acceptor (for example, a
display).
3. If required, connect a PC and/or controller to the RS-232 port and/or the
ETHERNET port (see Section
‎6.4
).
4. Connect the 5V DC power adapter to the power socket and connect the
adapter to the mains electricity (not shown in Figure 3 ).
5. If required, acquire the EDID (see Section
‎6.1
).
Press an INPUT SELECTOR button (from 1 to 4) to choose which DVI input to
route to the output.
i