Kramer Electronics VS-41HDCP - Manual (Page 25)

22 VS-41HDCP - Kramer Protocol
10 Kramer Protocol
You can download our user-friendly Software for Calculating Hex Codes for
Protocol 2000
” from the technical support section on our Web site at
http://www.kramerelectronics.com .
Section ‎10.1 describes how to switch between Protocol 3000 and Protocol 2000.
Section ‎10.2 defines Protocol 3000 and Section Error! Reference source not
found. defines Protocol 2000.
By default, the VS-41HDCP is set to Kramer’s Protocol 3000, but it is also
compatible with Protocol 2000.
10.1 Switching Protocols
You can switch protocols either via the front panel buttons (see Section
‎10.1.1
) or
by sending protocol commands (see Section ‎10.1.2 ).
10.1.1 Switching Protocols via the Front Panel Buttons
To switch from Protocol 3000 to Protocol 2000, press and hold the INPUT 1 and
INPUT 2 buttons for a few seconds (not as part of the switching operation).
To switch from Protocol 2000 to Protocol 3000, press and hold the INPUT 1 and
INPUT 3 buttons for a few seconds.
The Windows®-based Kramer control software operates with Protocol
2000. If the VS-41HDCP is set to Protocol 3000, use the front panel
buttons to switch to Protocol 2000
10.1.2 Switching Protocols via Protocol Commands
To switch from Protocol 3000 to Protocol 2000, send the following command:
#P2000<CR>
To switch from Protocol 2000 to Protocol 3000, send the following command:
0x38, 0x80, 0x83, 0x81
i