RADWAG WLC 0,6/A1/C/2 Precision Balance - Manual (Page 27)

- 27 -
14. RS 232 PARAMETERS
External devices connected to RS 232C have to be supplied from the
same mains and common electric shock protection. It prevents from
appearing a potential difference between zero leads of the two devices.
This notice does not apply to the devices that do not use zero leads.
Transmission parameters:
 Baud rate - 2400 – 38400 bit / s
 Data bits - 7,8
 Stop bits - 1,2
 Parity control - no, even, odd
There are four ways of sending data via RS232 interface:
 Manually – after pressing ,
 Automatically – after stabilizing the indication over -LO- threshold
 Continuously – after it is activated in parameter or by a command
sent via RS232
 On external request - see - „List of scale - computer commands”.
The indication can be sent as:
 stable – the indication is sent after the scale stabilizes.
 any – the indication is sent immediately after pressing the key,
this state is assign with <?> in the printout.
14.1. Printout type
This parameter is to select the type of printout.
Procedure:
 Enter the submenu <P2.Prnt> and then: