MyWeigh FLIPSCALE INTERACTIVE User Manual
Flipscale fi
FLIPSCALE Fi
Low Batteries & bad battery connections are the #1 cause of scale malfunction and inaccuracy! We
test all of our scale returns from consumers. Fully 60% of consumer returns are battery related
problems. This sounds silly but it's true! A scale will perform slowly, or read inaccurately when it has low
batteries. Please replace the batteries often (and only use good quality batteries). We include good
quality batteries with all of our scales but batteries can run low in storage. If your scale simply won't
turn on while on Battery power, this is often caused by loose battery connections. Battery prongs
(terminals) are made of metal. They must be making good contact with your batteries in order for the
scale to power on. You can use a paperclip to slightly bend the battery prongs to make them have a
better connection. Also some poorly designed batteries have recessed or partially obstructed battery
terminals. This may cause your prongs to be touching the plastic housing of the battery instead of the
metal battery terminal.
This is the Owners Manual and Calibration guide for the Flipscale Interactive The iFlip uses the same
internal program as the Palmscale 5.0. So, for advanced programming information, please view the
.
OPERATION and CALIBRATION INSTRUCTIONS
The FLIPSCALE Fi is very easy to operate. However, there are certain caring and operation instructions
you should read before your first use We know taking the time to read these instructions is time
consuming, but this scale is a precision instrument and must be handled with the utmost care.
IMPORTANT:
1)To open the scale simply lift up on the cover
2) To release the jewelers slide the black switch on the bottom
of the scale.*! be extra careful to re-install the scoop correctly!
Be certain it is not prying up on the tray*There is a storage slot
inside the Carrying pouch to hold your gemstone tweezers.
3) Always empty the tray/platform before turning the power on (clear
the platform before turning on)
4) Do not get the scale wet or hot and do not operate on any wet or
hot surface To clean the scale, wipe the surface with a clean damp
cloth or mild non-abrasive cleaner. Do not use an abrasive
cleaner because it may damage the finish.
5) Do not overload the scale. That is, do not place anything that
weighs more then 200 Grams on the platform. You may
permanently damage the load cell.
6) Handle the scale with care. This is a precision instrument and
should never be dropped or otherwise mishandled