Seiwa SW AP03 - Manual (Page 14)

CHAPTER 2 OPERATING INSTRUCTIONS
2.1 THE CONTROL PANEL
The front panel of the Controller (Figs 2.1) contain a text and graphics display, and course
error lamps keys. The TM80.03 also has a course adjust knob. The use of the controls is
described in this chapt
Figure 2.1 The AP03 Controller panel.
2.2 GETTING STARTED
Before operating the autopilot for the first time, it must be installed and adjusted as
described in Chapter 3. (If optional attachments and interfaces are being used, these can
be fitted after initial trials of the system.)
To switch on for the first time, press the STANDBY key. The system enters a set-up mode to
ensure that the steering drive and rudder transducer have been phased correctly.
13
13