Seiwa SW AP03 - Manual (Page 22)

20
The content of the three menus is shown below. Select one by pressing MODE or one of
the arrow keys. The active menu option is marked with >. Use short presses of the MODE
key to scroll down. To exit the menu, press the STANDBY or PILOT key. The active menu
option is adjusted by pressing the left or right arrow keys.
The contents of the three menus is shown below.
MENU 1 USE < >
HELM ADJ 02 P
> BACKLIGHT 2
RATE GYRO OFF
HEAD ADJUST 001
AUTO COMP CAL
MAN COMP CAL
COLD START
MENU 2 USE < >
HELM DEADBND 1
> RUDDER LIMIT 20
HELM DAMPING 2
RATE FACTOR 2
HELM ALERT 0
VARIATION 013
AUTOTRIM 1
MENU 3 USE < >
COMPASS MONIT
NMEA OUT HDG
>HEADING FLUXGATE
STEER DRIVE
REMOTE LOCK OFF
STALL ALARM ON
TACK ANGLE 100
TUNE MONITOR
Menu 1
BACKLIGHT The backlight for the display can be set to 4 different brightness levels. Use
the arrow keys to adjust.
RATE GYRO If a TM84.37 is fitted or a TM86.26 rate gyro has been fitted as an optional
attachment, the gyro function is turned on or off via the arrow keys.
HELM ADJUST For best overall performance, it is important that the displayed rudder
angle be adjusted to read zero when the helm is dead ahead. This
adjustment compensates for errors in the transducer linkage and
other offsets in the steering gear. The current helm angle is
displayed and should read 00 at the centre. Use the arrow keys to
trim the reading.
HEADING ADJUST The current fluxgate heading is displayed and compass mounting
errors may be compensated using the arrow keys.
20