Alpine eX-10 - Manual (Page 10)

Connect the eX‐10’s display to the base by
pushing down until you hear a “click”. Turn on
the ignition to power up the eX‐10.
To select the desired language, push the
“setup” button, then use the >>I button to
scroll down to “general”. Tap “enter” twice,
then select your language using the I<< and >>I
buttons. Tap “enter” to select.
You’re still in “setup” mode, so tap the >>I button three
times until you get to “Output Mode”. Tap “enter”,
and use the >>I button to select “Wire Transmitter” when
using the KWE‐155B antenna splitter, or “Aux” when using
the eX‐10’s auxiliary output.
Now, tap the button to get back to the “ Setup”
menu.
Installation Instructions
Step 7: Set up the eX‐10 to work correctly
Page 10
Step 7a: Setting language and output mode