Lenovo THINKSERVER TD230 - Manual (Page 109)

Table 15. Submenus under the Memory RAS and Performance Configuration
Item Option Description
Select Memory RAS Configuration Select the RAS configuration for
installed memory modules.
NUMA Optimized Disabled / [Enabled] Whether the BIOS contains the ACPI
configuration form required by NUMA
OS.
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 16. Submenus under the Mass Storage Controller Configuration
Item Option Description
Onboard SATA Controller Disabled / [Enabled] Enable or disable the integrated SATA
controller.
SATA Mode [Enhanced] / Compatibility / AHCI /
SW RAID To select the SATA mode.
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 17. Submenus under the Serial Port Configuration
Item Option Description
Serial A Enable Disabled / [Enabled] Enable or disable the serial port 1 I/O.
Address [3F8] / 2F8 / 3E8 / 2E8 Select the serial port 1 I/O address.
IRQ 3 / [4] Select the serial port 1 I/O interruption.
Serial B Enable Disabled / [Enabled] Enable or disable the serial port 2 I/O.
Address 3F8 / [2F8] / 3E8 / 2E8 Select the serial port 2 I/O address.
IRQ [3] / 4 Select the serial port 2 I/O interruption.
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 18. Submenus under the USB Configuration
Item Option Description
USB Controller [Enabled] / Disabled Enable or disable the USB function.
Legacy USB Support Disabled / [Enabled] / Auto Enable or disable the support on
legacy USB devices.
Port 60/64 Emulation [Enabled] / Disabled Enable or disable the I/O port. This
function is for the operating system
that does not support on legacy USB
devices.
Make USB Devices Non-Bootable [Disabled] / Enabled Set the USB device as non-bootable
device.
Device Reset Timeout 10 sec / [20 sec] / 30 sec / 40 sec Set the device reset timeout.
USB 2.0 Controller [Enabled] / Disabled Enable or disable the USB 2.0
support.
Note: The settings in [ ] are the default settings in the Setup Utility program.
Chapter 6 . Configuring the server 99