Lenovo THINKSERVER TD230 - Manual (Page 66)

Note: Use any documentation that came with the PCI card and follow those instructions in addition to
the instructions in this section.
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 23.
3. Lay the server on its side for easier operation.
4. Locate the PCI card you want to remove. Then, depending on the type of the PCI card, you might need
to disconnect any cables from the PCI card or the system board.
5. Remove the screw that secures the PCI card. Then, grasp the PCI card by the edges and carefully pull it
out of the PCI card slot. If necessary, alternate moving each side of the PCI card a small and equal
amount until it is completely removed from the slot.
Figure 45. Removing a PCI card
If you are instructed to return the removed PCI card to the manufacturer, follow all packaging instructions
and use any packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to “Completing the parts replacement” on page 90.
Installing or removing the Ethernet card
This section provides instructions on how to install or remove the Ethernet card.
56 ThinkServer TD230 Installation and User Guide