Lenovo THINKSERVER TD230 - Manual (Page 111)

Table 22. Items under the Server Management menu (continued)
Item Option Description
FRB-2 Enable [Enabled] / Disabled
OS Boot Watchdog Timer [Disabled] / Enabled
OS Boot Watchdog Timer Policy [Power Off] Default. Cannot be modified.
OS Boot Watchdog Timer Timeout [10 minutes] Default. Cannot be modified.
Plug & Play BMC Detection [Disabled] / Enabled
ACPI 1.0 Support [Disabled] / Enabled
Console Redirection [Disabled] / Serial Port A / Serial Port
B
System Information View the system information.
Baseboard LAN configuration Use this option to configure the
Baseboard LAN.
Intel (R) RMM3 LAN configuration Use this option to configure the
RMM3 LAN.
BMC LAN Configuration
User configuration Use this option to configure the user
ID and password.
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 23. Items under the Boot Options menu
Item Option
System Boot Timeout [0]
Boot Option #1 Use this option to set the first boot device.
Boot Option #2 Use this option to set the second boot device.
Boot Option #3 Use this option to set the third boot device.
Boot Option #4 Use this option to set the fourth boot device.
Network Device Order Use this option to set the network device boot sequence.
Delete Boot Option Delete boot options.
EFI Optimized Boot [Disabled] / Enabled
Boot Option Retry [Disabled] / Enabled
Note: The settings in [ ] are the default settings in the Setup Utility program.
Exiting the Setup Utility program
After you finish viewing or changing settings, press Esc to return to the Setup Utility program main menu.
You might have to press Esc several times. Then, you can do one of the following:
• If you want to save the new settings and exit the Setup Utility program, press F10. Otherwise, your
changes will not be saved.
• If you do not want to save the new settings, select Exit ➙ Discard Changes and Exit.
• If you want to return to the default settings, press F9 or select Exit ➙ Load Default Values.
Using passwords
By using the Setup Utility program, you can set a password to prevent unauthorized access to your server
and data. The following options are available to help you set an administrator password or a user password:
Chapter 6 . Configuring the server 101