Konica Minolta bizhub PRESS C8000e - Manual (Page 162)

About the network setting (Fiery controller) Chapter 8: Application
8-12
• About the details of settings, refer to the User's Guide provided with Fiery controller.
• If you don’t want to reboot immediately, click [Cancel] after clicking [Apply]. In this case,
modified settings are saved and will be available after the next restart of the controller.
4.
From [Select Protocol],
select protocol to use.
5.
Set [IP Address] and
[Subnet Mask].
6.
When you use IPv6 addresses, click [Enable IPv6] check
box and enter the address to [IPv6 Address].
7.
From [Select Gateway address], select [automatically] or
[manually].
• If [automatically] is
selected: Go to Step 4 • If [manually] is selected:
Go to Step 8
8.
Set [IP Address].
9.
Click [Apply].
10.
Set the other settings as required and click [Reboot].