Konica Minolta KIP C7800 - Manual (Page 75)

KIP Request Operator Guide
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP. © 2011 KIP.
- 71 -
sorted by their names (ascending, descending), by size or by modified date. The value here is used for
troubleshooting purposes.
FileType=6
This displays how many entries that are available under ‘Browse for’ section inside Request software. For
diagnostic purposes only.
StatusDelay=30
Sets time in seconds that Request software will wait to read status
information (roll information, error condition) from the printer.
PenDir=C:\Program Files\KIP\Request\Pens\
Records and displays location of the ‘Pen table’ being used for printing.
LastPen=DEFAULT.PEN
Records and displays the last ‘Pen table’ used for file submission
LastDir=C:\Programs\DS
Records and displays the last folder where the files were printed from.
DefaultRequester=TJANISSE
Shown here using an environment variable called UserName. You may also enter information after the
“=” that will be displayed in the REQUESTER field each time the Software is started. Up to 30 characters
may be used.
DefaultDistribution=
Shown here using an environment variable called Distribution. You may also enter information after the
“=” that will be displayed in the DISTRIBUTION field each time the Software is started. Up to 30 characters
may be used.
DefaultDescription=
Shown here using an environment variable called Description. You may also enter information after the
“=” that will be displayed in the DESCRIPTION field each time the Software is started. Up to 30 characters
may be used.
Prompt=Job Number:
RequesterPrompt=Requester:
This line allows the user to customize the Requester field name.
DescriptionPrompt=Description:
This line allows the user to customize the Description field name.
ReportFont=Courier New
ReportFontSize=12
DotEnhancement=0
CopyDensity=0
TextSize=0.00"
A KIP text header will be applied to raw files dropped into a monitor path.
This value determines the size of the header, in inches.
TextPos=1
A KIP text header will be applied to raw files dropped into a monitor path.
This value determines whether the header appears on the Leading Edge (0), or Trailing Edge (1).
Language=1
The next section contains the paths to the internal programs that Unattend uses to detect, convert,
merge, and move files. If the required programs are not in these default locations, a Runtime Error 53
(File Not Found) will occur.
ExportExe=C:\PROGRAMS\DS\MTP.EXE