Arturia JUPITER-8V 2 - Manual (Page 101)

ARTURIA – JUPITER-8V – USER’S MANUAL 101
Click on the “Range” selector of VCO1
Choose the modulated square waveform on VCO2
Choose the modulated square waveform on VCO2
Set VCO 2 slightly out of tune by turning the “Fine Tune” knob a little bit. The sound
will become more alive.
Set VCO 2 slightly out of tune
Lower the cut off frequency of the filter («FREQUENCY») by positioning the knob in
the center (around «400 Hz»). That will allow you to return to a softer sound. You
will hear the effect that the envelope will produce on the filter.
Lower the cut off frequency of the filter
On the ADSR envelope situated to the right of the filter, increase the attack time to
a value close to «100MS». Lower the knob of the Decay (set it to a value around