Arturia JUPITER-8V 2 - Manual (Page 109)

ARTURIA – JUPITER-8V – USER’S MANUAL 109
The interface of the Jupiter-8V sequencer
Open the Galaxy module to complete the rhythm. This will modulate the volume of
the VCA to create «gate» effects that are often used in electronic music.
Click on «Output X' (situated to right of galaxy) and choose «VCA» as destination of
modulation controlled by LFO 1 (axis «X»).
Do the same for the first destination of the axis «Y» while choosing also the
destination «VCA»
Set the two levels of modulation to the range of 0.600
Sync the Galaxy module to MIDI « Sync «
Select the speed of the LFO while clicking on « Q » (For « Quantized ») select a
value « 1/8 ».
Galaxy completes the sequence played by the step sequencer to finish your sound.
Setting of the Galaxy module
Finally the preset consists of:
• 2 VCOs (VCO2 as a 7 th tuning)
• A high pass filter (HPF)
• A low pass filter (VCF)
• An ADSR envelope connected to the filter
• An ADSR envelope connected to the amplifier
• The Galaxy module
• The Arpeggiator
• The step sequencer modulating the frequency of the VCF
• The Galaxy module modulating the volume of the VCA
• A LFO modulating the square waveform of VCO2
• Patch effect » Chorus / Flanger »