Arturia JUPITER-8V 2 - Manual (Page 78)

ARTURIA – JUPITER-8V – USER’S MANUAL 78
GLIDE Place an effect of portamento between the selected step and the following
step.
ACCENT Place an accent effect on the selected step.
The edit section of the sequencer
7.2.3 Outputs
The modulation destination (“OUTPUT”) is located to right of the interface of the
sequencer, where the synthesis parameters that will be affected by the sequencer are
selected.
It is also possible to connect the parameters of the voice effects to the sequencer. To do that, go to the
“Effects” / “Voice Effects” page. Then choose the source “Sequencer” among the choices of sources of proposed
modulations for the parameters of these effects. (see paragraph “Voice Effects” for more details)
Three connection locations are available for the sequencer. For each of them the
following destinations are available:
DESTINATION Choice of available modulation destinations
• None: Nothing is connected
• VCO1 Pitch: VCO1 FREQUENCY
• VCO2 Pitch: VCO2 FREQUENCY
• VCO1 PW: Pulse width of the square wave form of VCO1
• VCO2 PW: Pulse width of the square wave form of VCO2
• HPF Cutoff: Frequency of the high pass filter
• VCF Cutoff: Frequency of the low pass filter
• VCF Res: Resonance of the low pass filter
• VCA: Volume of the VCA
AMOUNT Sets the level of modulation
Q Quantification of the modulation settings by semitones. This parameter
is essential to regulate the levels of each step for the creation of a
melodic sequence
RETRIG Automatically place a «trig» envelope on all the steps.