Konica Minolta PS5000C - Manual (Page 18)

PS5000C Operator’s Manual
1-2
1 Precautions for Installation
1.1 Installation environment
Install the Scanner in a location, which meets the following requirements to ensure
safe operation and utmost performance.
‹ A place where the illumination onto the book table is less than 1000lx (e.g.
4.5m (15ft)×6.5m (21.5ft) area with ceiling height of 2.6m (8.5ft) and 12 or
less 40W fluorescent lamp.)
‹ A place where the illumination onto the book table is not uneven due to the light
from the lighting system or the outside through windows.
‹ A place away from curtains or other objects that catch fire and burn easily.
‹ A place where there is no possibility of being splashed with water or other
liquid.
‹ An area free from direct sunlight.
‹ A place not in the direct air stream from an air conditioner, heater, and/or
ventilator, ensuring fairly constant temperature.
‹ A well-ventilated place.
‹ A dry place.
‹ A dust-free location.
‹ An area not subject to undue vibration.
‹ A stable and level surface.
1.2 Power source
The power source voltage requirements are as follows.
‹ Use a power source with little voltage/frequency fluctuations.
Voltage fluctuation: Up to 120 VAC ±10%, 230 VAC ±10%
Frequency fluctuation: Up to 50 Hz ±3 Hz
Up to 60 Hz ±3 Hz
‹ If any other electrical equipment uses the same power outlet, make sure that the
capacity of the outlet is not exceeded.
‹ The outlet should be located near the Scanner and easily accessible so that
power cord can be pulled out whenever necessary.
‹ NEVER use a multiple adapter to connect other equipment or machines to the
outlet used by the Scanner.
‹ If an extension cord is required, use one with a capacity higher than the power
consumption of the Scanner.
‹ Make sure that no unusual, excessive force is applied to the power cord or
extension cord.